In this Tab, adding Communication Cables or other wires to the attachment is possible.

 

Important Note: Cables can be attached to many wire types unless they are flagged special in the database that they cannot support cable attachments. If you add cables to a wire and then select a wire category, a Dialog will appear asking you if you wish to keep these cables attached. This default behavior was put in place because it is quite common for users to evaluate the Sags & Tensions of various items on a pole (Power or Communications) and switch between wire types. If the cables were left in place, Users could get incorrect results and not be aware that the cables were still attached.

 

Selecting Yes will retain the cables and No will remove these cables.

 


The ability to add cables or wires to this attachment is the same as within a project. Please refer to the Span Editor's Edit Cables & Tensions section for more information. This same section describes the cable bundle tab and the wire parameters tab as well.