QP Update 7.04.18 - Maintenance Release
Posted: Tue Dec 10, 2024 11:58 am
This is a small update to improve/correct a few things found.
1. To address some possible inaccuracies in IKE data if the handheld device is not calibrated well, there are times when the originating location at the start of a span can create an End of Study (EOS) pole instead of starting at the pole it was recorded from. This update suppresses the EOS pole and forces Quick Pole to use the originating pole. Oftentimes, with uncalibrated devoices, EOS poles are still created for the far end, however. If this happens, highlight the real plus the EOS pole and use the "MERGE" function.
2. A user found that reports using very long Make Ready messages can prevent a certain report from printing. This has been corrected.
3. NESC support for Residential Driveways and their Clearance Requirements has been improved to a slightly lower value; where truck traffic is not expected. This is different than CSA rules where trucks are always expected (moving trucks, oil trucks...)
1. To address some possible inaccuracies in IKE data if the handheld device is not calibrated well, there are times when the originating location at the start of a span can create an End of Study (EOS) pole instead of starting at the pole it was recorded from. This update suppresses the EOS pole and forces Quick Pole to use the originating pole. Oftentimes, with uncalibrated devoices, EOS poles are still created for the far end, however. If this happens, highlight the real plus the EOS pole and use the "MERGE" function.
2. A user found that reports using very long Make Ready messages can prevent a certain report from printing. This has been corrected.
3. NESC support for Residential Driveways and their Clearance Requirements has been improved to a slightly lower value; where truck traffic is not expected. This is different than CSA rules where trucks are always expected (moving trucks, oil trucks...)