QP 7.04.10 - FRP (Composite) Pole adjustment
Posted: Tue Oct 22, 2024 9:32 am
This update includes a few bug fixes from the previous version, plus one specifically for FRP poles.
In FRP poles, some pole product configurations include cutting a length from the top of the pole. This was not recognized properly, which meant that poles would show themselves with a higher height above ground than was actually there. There would be little effect if you placed your attachments at heights measured in the field, but you could be mislead by its appearance. This update corrects this for FRP poles with a defined top cut.
In FRP poles, some pole product configurations include cutting a length from the top of the pole. This was not recognized properly, which meant that poles would show themselves with a higher height above ground than was actually there. There would be little effect if you placed your attachments at heights measured in the field, but you could be mislead by its appearance. This update corrects this for FRP poles with a defined top cut.