QP 6.73.90 - Several Feature Enhancements
Posted: Wed Dec 30, 2020 8:26 pm
The following features have been added in this update:
1) In both the Span Editor and the Structure Editor, attachment heights can now by edited based on:
a) Height above ground (as before)
b) Distance down from the Top of the Pole
c) Absolute elevation values.
2) The previous features in the Span Profile Editor that were shown but not enabled have now all been enabled. Among these are options to show a Clearance Height Requirement line, text and value on the profile, Attachment heights beside wires, plus several more.
3) Several Structure properties can now be edited directly in the Plan View window in the Properties Window on the right. Most simple properties can now be edited, which could be more efficient than using the Structure Editor window for minor adjustments, or where selecting structures in the Plan View and checking/editing specific values is more efficient for you; depending on your internal processes.
1) In both the Span Editor and the Structure Editor, attachment heights can now by edited based on:
a) Height above ground (as before)
b) Distance down from the Top of the Pole
c) Absolute elevation values.
2) The previous features in the Span Profile Editor that were shown but not enabled have now all been enabled. Among these are options to show a Clearance Height Requirement line, text and value on the profile, Attachment heights beside wires, plus several more.
3) Several Structure properties can now be edited directly in the Plan View window in the Properties Window on the right. Most simple properties can now be edited, which could be more efficient than using the Structure Editor window for minor adjustments, or where selecting structures in the Plan View and checking/editing specific values is more efficient for you; depending on your internal processes.