This update makes small adjustments in a few areas to Quick Pole that should help Designers.
1. GIS status indicators such as "GIS Features Enabled" or "GIS Features Possible if one pole's location is set" have been promoted and synchronized is several places so that you are always aware. The Coordinates Editor, Project Settings tab and the Edit Location Dialog. The lack of displaying this status information everywhere has lead to questions due to the lack of visible information.
2. IKE imports were adjusted to ensure that GIS features are enabled immediately afterwards.
3. In the Point Load Dialog, force and moment angles (on edit) will be consistently shown as positive angles. In other words, -115 will not be shown, but 245 degrees will. This is consistent with other places of displaying this angle.
4. Clearance objective values in drop-down choices, table values and in Span Profiles, now clearly show the lowest clearance value permitted to ground; which includes the Clearance Overrides in the Project Settings. This lowest value is that for all attachments in the span, but typically used for Communications on Joint Use lines.